Ah! E se falando em madeira...: equipando a bancadinha BD
Bore Vertical holes with scrap stock jig "Handy Woodworking Jig" Hope it helps you drill those holes in those dowels.. :)
Литература ,Проекты для Мастерской и Мебели Mais
Put these tips to work in your shop for quicker more efficient clamping.
Aligning corners presents a special challenge in woodworking because none of us seem to have enough hands for the task. Fortunately, the corner stays you see here will free up your hands to apply glue, drill pilot holes or drive screws without misalignment worries. They work better than a commercial corner clamp for holding a corner steady and leaving it exposed; plus they do it for a fraction of the cost. The corner stays are made from 2" binder clips epoxied to a steel corner brace ...